6.0L 5-Speed Dyno Day Today
#35
4 pages??? You should change your settings in the control panel. I'm not even done with page 1 yet. All these posts so far have been on the same page for me.
#36
Launching!
iTrader: (2)
The first time I got on the truck after the maggie, I launched in 2nd, grabbed 3rd was at about 3k it pulled like crazy, then I noticed the truck seemed not quite pull as hard and at about 4500rpm the clutch completely let go and the motor hit the rev limiter before I could get off the gas.
Good Luck
#37
TECH Fanatic
iTrader: (22)
Join Date: Apr 2006
Location: Yaphank NY
Posts: 1,779
Likes: 0
Received 0 Likes
on
0 Posts
Yeah My truck is quite a bit heavier, ECLB 2500hd with 33's weighs right about 6000lbs The torque is what really does the damage to the clutch. When I did my clutch the disc still had more than half of its life left, but the pressure plate and flywheel were both burnt.
The first time I got on the truck after the maggie, I launched in 2nd, grabbed 3rd was at about 3k it pulled like crazy, then I noticed the truck seemed not quite pull as hard and at about 4500rpm the clutch completely let go and the motor hit the rev limiter before I could get off the gas.
Good Luck
The first time I got on the truck after the maggie, I launched in 2nd, grabbed 3rd was at about 3k it pulled like crazy, then I noticed the truck seemed not quite pull as hard and at about 4500rpm the clutch completely let go and the motor hit the rev limiter before I could get off the gas.
Good Luck
#38
Hey Joe,
Glad to hear its running well
I'm just as excited to hear what the #'s are.
I think I may be bringing the Blue Turbo Notch up to BIR Wed night. Doug P (MaroonZ28) is going up there as well as a few others from MNFbody.
Where you dynoing?? If they cant get you in right away, I can call a friend in St.Boni that has a Dynojet.
Tim
Glad to hear its running well
I'm just as excited to hear what the #'s are.
I think I may be bringing the Blue Turbo Notch up to BIR Wed night. Doug P (MaroonZ28) is going up there as well as a few others from MNFbody.
Where you dynoing?? If they cant get you in right away, I can call a friend in St.Boni that has a Dynojet.
Tim