90mm UMI TB Conversion Complete - Pics inside
02-14-2007, 08:10 PM
#1
90mm UMI TB Conversion Complete - Pics inside
Just finished up the j-tube and umi throttle body install. Had to get a 4" coupling to mount the throttle body to the radix air tube, deleted my egr and blocked off the port on the header with a plate. I also had to have the throttle cable plate redrilled to and moved over slightly to make sure the cable were working at good angles.
I havent went WOT yet because I still need to get tuned. It does seem to have low throttle issues which I think (hope) can be tuned out. Runs more rough in when cold as well.
Im going to get tuned next week and hopefully report back a solid gain. I do have 100% throttle movement because it is not DBW. I am also going to have the meth turned up and hopefully a few more degrees of timing. I have 21 degrees now, so I think with more meth and this mod I should be able to see 25 degrees of timing.
I am hoping for 25rwhp which would put me right at the 500rwhp mark. I will be sure to report back with a new dyno graph next week.
I havent went WOT yet because I still need to get tuned. It does seem to have low throttle issues which I think (hope) can be tuned out. Runs more rough in when cold as well.
Im going to get tuned next week and hopefully report back a solid gain. I do have 100% throttle movement because it is not DBW. I am also going to have the meth turned up and hopefully a few more degrees of timing. I have 21 degrees now, so I think with more meth and this mod I should be able to see 25 degrees of timing.
I am hoping for 25rwhp which would put me right at the 500rwhp mark. I will be sure to report back with a new dyno graph next week.
J/K, happy for ya, I bet you make more than 25 out of it. Too bad you cant meet up with us for a run on Saturday 
