james8997

I'd like to run this intake on my 408 I'm building with 317 heads and a 76 mm turbo, is anyone else running one? Any pics? How's it perform? Did you have to drill it for a map sensor?

tarinitup

iTrader: (11)

Yes, works good, no need to tap for map just use hose.

JoeyGC5

iTrader: (24)

I use the Pro Flo on my turbo truck. Top end versus the stocker is much better. But on the small 5.3 the low end kinda sucks. Plenty of ports for sensors and what else

james8997

So it should shine on a 408? What all needs to be plumbed into it? Just a map?

GetBlown01

iTrader: (6)

Not to hijack this thread, but does the intake work with the stock truck injectors?

JoeyGC5

iTrader: (24)

Itake should work with stock injectors, as my Bosch 80's are same heighth.

On your 408 it should work fine, imo might need minor porting for worked over heads. I only use a vac line to blow off valve anf then the map sensor. All other ports are blocked on my truck.

james8997

What about a vacuum line for your brakes?

o2camaross

iTrader: (2)

Probably has hydroboost

JoeyGC5

iTrader: (24)

I have hydroboost. But there is a 1/4" npt port on the intakes rear that can be used to plumb into the vacuum brake booster.