Turbo oil feed source
11-16-2011, 03:16 PM
#14
TECH Senior Member
iTrader: (10)
Join Date: Oct 2004
Location: Crystal Springs, MS
Posts: 14,068
Likes: 0
Received 2 Likes
on
2 Posts
Atomic has a funny colored torque converter......
but thats the same thing i did on my turbo setup.. Drill and tap the blockoff plate for 1/8"NPT and put in a -4 fitting. vola.
but thats the same thing i did on my turbo setup.. Drill and tap the blockoff plate for 1/8"NPT and put in a -4 fitting. vola.
it pretty much drains out the whole oil supply system of the motor, all the oil passages and everything. Let just say, have a catch pan ready 
11-22-2011, 04:20 PM
#19
On The Tree
Join Date: Jun 2011
Location: Rapid City South Dakota
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
on the master power and magnum turbos an 1/8th in pipe fitting threads into the feed side , so i didnt need to use any flange on the feed side
Last edited by M&M Turbochargers; 11-22-2011 at 04:21 PM. Reason: not sure if it was npt , but was from hardware store
Thread
Thread Starter
Forum
Replies
Last Post
