value of roush tvs1900
#14
TECH Fanatic
Thread Starter
iTrader: (14)
Join Date: Jul 2008
Location: flemington nj
Posts: 1,103
Likes: 0
Received 0 Likes
on
0 Posts
It may, I'm not to sure. Could always pulley it a little harder and run a waste gate on it so you hit higher boost early and bleed it off so you dont make 30# s. sounds good in theory in my head at least haha
#15
TECH Junkie
I think thats what ECS was doing to Vettes a few yrs ago.
#16
Baltimore Whore
iTrader: (95)
Join Date: Apr 2004
Location: In a van DOWN BY THE RIVER
Posts: 16,820
Likes: 0
Received 2 Likes
on
2 Posts
Displacement blowers do well, but not in a cam'd geard app... They just don't or have not posted the times of other stuff. Everyone goes the turbo route, good reason being they are fast. i have always been with PC so I will stay there. I like to stay out of the box, but PC chit runs well also
#17
TECH Fanatic
Thread Starter
iTrader: (14)
Join Date: Jul 2008
Location: flemington nj
Posts: 1,103
Likes: 0
Received 0 Likes
on
0 Posts
Its no doubt a procharger works. Hell there are f1r going 4.80s in the 1/8 @ something like 3100# in x275. What got me on this kick is my tuner just went 10.01 in a tbss. It put down 1033 to the wheels on f1r.
Side note, the one in classifieds may be mine today... :x
Side note, the one in classifieds may be mine today... :x
#18
TECH Fanatic
Thread Starter
iTrader: (14)
Join Date: Jul 2008
Location: flemington nj
Posts: 1,103
Likes: 0
Received 0 Likes
on
0 Posts
Displacement blowers do well, but not in a cam'd geard app... They just don't or have not posted the times of other stuff. Everyone goes the turbo route, good reason being they are fast. i have always been with PC so I will stay there. I like to stay out of the box, but PC chit runs well also
#20
TECH Fanatic
Thread Starter
iTrader: (14)
Join Date: Jul 2008
Location: flemington nj
Posts: 1,103
Likes: 0
Received 0 Likes
on
0 Posts
when we tuned my truck on the street my tuner/buddy said he thinks around 480-500 based off of injector duty cycle. when i told him it trapped 115 at 5050# we looked at the numbers and it should take about 560 to do that, mind you the DA was negative by a lot so it would correct to be lower. we tried to dyno it at his shop and the truck was too low to fit, we could have made it work by driving up on ramps but it was a dyno day and would take to long to mess with it.