sierraboy

so i can get a use one and it wont be a problem ill just have to get it balance correct

and buy new ujoint ect..ect..

AKlowriderZ71

iTrader: (22)

If you're converting from a 1 piece to the 2 piece, you'll need to build a crossmember for the support bearing. And pay attention to the driveline angles. That's about it!

lady3bglover

iTrader: (3)

Correct.

There's also an alignment kit that Beltech has, that I can show you the link for. You don't have to get it, it just preventative.

sierraboy

oh ok well i just align my pinion angle do to the fact that i had bad vibration at 30 and 70 well pinion angle is align but the vibration is stil there but not as much as it use to be

guys what do yall think it is now

lady3bglover

iTrader: (3)

Did you get it balanced? And what about the carrier bearing, did you replace it?