anfking6908

Well ive had hell since day one with my transmission ever since it overheated. It is throwing two codes right now. P0748 & P0706. I can clear the codes on my truck and as soon as i start the truck back up the 748 pops back up. I just hooked my tow/haul button back up b/c the guy i had rebuild it cut the wire. Well how hard would it be to check and see if he left the pressure sensor unhooked inside of the transmission? and can i do it with out dropping the transmission?

performabuilt

iTrader: (24)

Those two codes are not related codes and are both circuit electrical codes , I would suggest checking the wiring harness that its plugged in good and look that there are no wires exposed or pinched in the trans harness.

Wheatley

iTrader: (12)

How did I know Frank would post soon!!LOL
Good advise Frank

performabuilt

iTrader: (24)

Its what I do

Wheatley

iTrader: (12)

Thats a good thing

performabuilt

iTrader: (24)

Yep and check out the new addition to my signature

anfking6908

yes all the wires are plugged in and none seem pinched at all

performabuilt

iTrader: (24)

You should also check that the internal harness didnt get pinched between the case and the pan a common enough builder error.

anfking6908

how do i check the internal wires?

performabuilt

iTrader: (24)

Pull the pan and inspect over near the plug that the wires were not pinched between the pan and case