4l60e build with $100 core...
#576
Thread Starter
TECH Senior Member
iTrader: (5)
Joined: Jun 2013
Posts: 5,492
Likes: 36
From: Virginia Beach,VA
So, been a while lets see if i can recap what has happened, the travs developed a leak what seemed like from the pump seal, let it sit for way to long, finally got around to swapping engine mounts and starting ti tear the trans out and the leak had stopped......been dealing with a battery not staying charged off and on for longer than i care to admit, finally traced it down to the remote start cell phone signal device thingy no longer being supported by directed/viper and constantly searching for signal being the culprit.. 6-7 batteries later..... hey what can i say warranty is awesome!!! Lol!! Then in the midst of all of that and finding time to get the current batteries charged andte fact i cant keep 2 vehicles where i am currently staying.... someone tried to break into the truck by prying the driver side door handle off, luckily all they did was break the pull handle off....so i seapped out the chrome driver handle and realized i want to go back to black handles now..... also ended up needing to put a nee set of turn signals in it, along with a left fog lamp(lens fell off) a left outer tie rod, and in tge next day or two she will get a master cylinder and a brake flush.... keep losing brakes and pedal going to floor but no leaks figure at 267800 mikes the factory master has seen its best days lol..... think thats about it for now.....
Thread
Thread Starter
Forum
Replies
Last Post
FLT
GM Drivetrain & Suspension
47
09-08-2008 06:03 PM