80e Swap - Check list and ??
#52
TECH Apprentice
I think the O'ring might be stopping it...it's a very tight fit.
It needs to push all the way through and lock in...obviously.
EDIT: I think it can only go in in one orientation also...so maybe try turning it.
It needs to push all the way through and lock in...obviously.
EDIT: I think it can only go in in one orientation also...so maybe try turning it.
#55
TECH Apprentice
Yeah....thought it was out of whack. The other pic shows it on an angle (looking at the flat sections inside the plug). Now they run parrallel with the trany.
#58
TECH Apprentice
I asked around because I was thinking the same thing when I did mine. I'd never opened an auto trany before so was 'scared' Lol!
Everyone suggested....I might as well go the whole hog and do the springs etc.
Glad I did.
I did it all with no special tools.
All's needed is rattle can lids and hose clamps (seal resizers), clear plastic sheet (lip seal inserting tool)...etc.
Everyone suggested....I might as well go the whole hog and do the springs etc.
Glad I did.
I did it all with no special tools.
All's needed is rattle can lids and hose clamps (seal resizers), clear plastic sheet (lip seal inserting tool)...etc.
#60
I asked around because I was thinking the same thing when I did mine. I'd never opened an auto trany before so was 'scared' Lol!
Everyone suggested....I might as well go the whole hog and do the springs etc.
Glad I did.
I did it all with no special tools.
All's needed is rattle can lids and hose clamps (seal resizers), clear plastic sheet (lip seal inserting tool)...etc.
Everyone suggested....I might as well go the whole hog and do the springs etc.
Glad I did.
I did it all with no special tools.
All's needed is rattle can lids and hose clamps (seal resizers), clear plastic sheet (lip seal inserting tool)...etc.
I have a feeling this is gonna be a slow going modification.
Thread
Thread Starter
Forum
Replies
Last Post
iregret
GM Parts Classifieds
3
07-27-2015 10:32 PM
GreyChevy
Tuning, Diagnostics, Electronics, and Wiring
1
07-07-2015 08:57 PM