gen III 4.8 4l60e to gen IV 6.2 6l80e
#4
We did this exact swap at my work.
We used a piggy back controller from https://www.powertraincontrolsolutions.com/
It intercepts the signals from the 411 PCM and sends out new CAN bus signals to the 6L80's TCM. The 6L80 TCM relies on an accurate engine torque signal over the bus.
We used a piggy back controller from https://www.powertraincontrolsolutions.com/
It intercepts the signals from the 411 PCM and sends out new CAN bus signals to the 6L80's TCM. The 6L80 TCM relies on an accurate engine torque signal over the bus.
Thread
Thread Starter
Forum
Replies
Last Post
moto_andrew
Tuning, Diagnostics, Electronics, and Wiring
1
01-06-2016 07:41 AM
dantheman1540
GMT 800 & Older GM General Discussion
2
01-05-2016 06:24 PM