KySilverado

iTrader: (7)

4" Custom length aluminum with 1350 joints. High speed balanced from DS specialists in TX. About $550 shipped best I remember.

fastnblu

iTrader: (2)

Roger , how long is that? Is that a custom length cause u went from 1 2pc. shaft to a 1pc.? Cause that's 1 of the more $ shafts I've read on here. Long as it works tho for 11s.

KySilverado

iTrader: (7)

I don't remember the length .... heck I can't even remember if its longer or shorter than the original shaft. Had to have it with the 80e swap. 4" made it more expensive.

The stocker went 11's many times also. It was a one piece too.

fastrt

iTrader: (48)

DS specialist are good! those 1350 u-joints dont look to much beefier than the 3R u-joints. Is there a big difference Roger?

fredkj3

iTrader: (1)

they arent too much bigger.. but they are bigger....

Atomic

iTrader: (42)

The 3R is the same thing as the S44 and Saginaw joints, similiar to a 1330.

To steal a chart from pirate4x4,

05_GMC

What is the stock leagth an diameter for a driveshaft in a rcsb fleetside if i were want to order an aftermarket ds.

bansheerider44

iTrader: (5)

4" chromoly nitrous ready shaft from Dennys, 1350 mark williams solid u joints, strange 80e chromoly yoke. think it was $750-$800.... its holding up so far