Let's See Your 2 Piece D/S swaps!!
#1
TECH Enthusiast
Thread Starter
iTrader: (2)
Join Date: Sep 2009
Location: ft worth texas
Posts: 598
Likes: 0
Received 0 Likes
on
0 Posts
Let's See Your 2 Piece D/S swaps!!
I'm gonna do a 2 piece DS in place of my 1 pc.
It's a crew cab 4wd. 143.5 WB
If you have pictures of your carrier bearing cross member post em up. I've read a few threads but not that many good pics or they were on a rcsb
It's a crew cab 4wd. 143.5 WB
If you have pictures of your carrier bearing cross member post em up. I've read a few threads but not that many good pics or they were on a rcsb
Trending Topics
#8
TECH Regular
iTrader: (11)
Join Date: Oct 2007
Location: Roseville, CA
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
I blew up my one piece at the track and used a ECSB 2 piece.
I had to do a couple of changes to make it work but I wanted to keep as many parts fatory GM as possible.
The crossmember was removeable and I set up the u-joint angles to work with my 6" drop in the rear.
I had to do a couple of changes to make it work but I wanted to keep as many parts fatory GM as possible.
The crossmember was removeable and I set up the u-joint angles to work with my 6" drop in the rear.
#9
TECH Enthusiast
Thread Starter
iTrader: (2)
Join Date: Sep 2009
Location: ft worth texas
Posts: 598
Likes: 0
Received 0 Likes
on
0 Posts
This is what i was looking for. I was wondering how far back the crossmember had to be as I was seeing it was close to the fuel tank. Thanks for the pics. Did you have to do anything special as far as driveline angles? I assume just build the crossmember to suit your angles? Correct?
#10
TECH Regular
iTrader: (11)
Join Date: Oct 2007
Location: Roseville, CA
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
The centerline of the carrier bearing is 45" from the face of the transmission crossmember and everything else falls in place from there. Luckily I had an ECSB to take measurements for comparison. From what I remember I had 2.5 degrees for the u-joints and 5.5 degrees at the pinion. The only rework I really had to make was rotating the Evap canister similar to how the ECSB.