LQ4 swap into a 57 chevy truck
#1
#3
Thanks
I was checking them out on ebay last night .... but think it said something like
1/2" rear or up to 2 1/4 " forward.
Think I need further back (rear)
On the site
"Dingo Sliders will allow you to mount the engine in the original bell housing position, or move the engine forward up to 2 inches. May require using aftermarket oil pan."
I was checking them out on ebay last night .... but think it said something like
1/2" rear or up to 2 1/4 " forward.
Think I need further back (rear)
On the site
"Dingo Sliders will allow you to mount the engine in the original bell housing position, or move the engine forward up to 2 inches. May require using aftermarket oil pan."
Thread
Thread Starter
Forum
Replies
Last Post
Glenn98ZM6
GMT 800 & Older GM General Discussion
5
08-20-2017 04:04 PM
KitsBeach
GM Drivetrain & Suspension
2
04-30-2017 12:20 PM
JeRM82
GMT 800 & Older GM General Discussion
25
01-10-2011 07:39 AM
DaDon357
GM Engine & Exhaust Performance
11
05-21-2008 12:42 PM