LesPaul

Hey guys. any of you have a good way of removing trans to engine dowl pins.... my 6.0 seemed to have pulled out the pin from the old trans. and when i pulled my 5.3 it left the pin in the trans... you can see my issue here.... i have been spraying it with pd blaster and beating it with a hammer..... better way to do this??? or keep banging till my arm falls off?? thanks

Les

TurboBerserker

iTrader: (1)

Maybe an air hammer?

dirt track racer 81

iTrader: (45)

i used a pair of pliers to pull mine out

Nick™

iTrader: (2)

pliers to pull it out... not sure why you are beating it with a hammer, there's no where for it to go

LesPaul

pliers@!@!@!1..... holy crap guys you must be strong as hell.... lol lol hell i will give it a try

LesPaul

are you guys sure we are talking about the same pins... thier is no way to pull those out with a pair of pliers....

99Silver6.0

iTrader: (1)

Try some Visegrips!

1SlowHoe

iTrader: (28)

Dynamite would do it

Zick

iTrader: (18)

I used a junk 3/8" extension and beat it with a BFH from the back side.

LesPaul

I was trying that couldnt get enough room to get a good hit with a hammer.... well crap i dont know what the hell im going to do now..... problem after problem trying to this damn engine in.... im going to set this bitch on fire.... shoulda been running last week