trans installed, now no-start
#1
TECH Enthusiast
Thread Starter
iTrader: (18)
Join Date: Feb 2004
Location: central east coast florida
Posts: 560
Likes: 0
Received 0 Likes
on
0 Posts
trans installed, now no-start
i have replaced the 2-4 band in my 03 yukon today. re-installed everything and now the truck will not start. i have all lights and chimes, the indicator lights work as i move the shifter through the range, we've tapped the starter while turning the key - nothing. When the key is put to start position all i get is silence.
any thoughts - this is on a 2003 yukon 5.3 4wd
oh and i also have "service 4wd" and "check brake booster" on in my display
thanks everybody
any thoughts - this is on a 2003 yukon 5.3 4wd
oh and i also have "service 4wd" and "check brake booster" on in my display
thanks everybody
#3
TECH Fanatic
iTrader: (3)
Join Date: Mar 2010
Location: van nuys CA
Posts: 1,026
Likes: 0
Received 0 Likes
on
0 Posts
re check ur wiring.. did u disconnect the battery when u dropped the tranny? if u didnt check ur fuses may b when u were taking off the starter u made a short and blew a fuse.. other then that idk man.. check ur p to N safety connector..
Trending Topics
#8
TECH Enthusiast
Thread Starter
iTrader: (18)
Join Date: Feb 2004
Location: central east coast florida
Posts: 560
Likes: 0
Received 0 Likes
on
0 Posts
never mind on that question. its the block on the side of the case.
i had to tap the top connector into this for it to sit. after tryign to start the truck with no luck, i unplugged both connectors to make sure none of the pins were bent. none were, tried to put the connectors back in and they wouldnt go, so i pulled the weather connector out and tried, i got them back in without tapping. think i messed this thing up? anyway i can check this, make sure the adjustment is right? when i put the truck in park, it does unlock the doors and stops the truck from rolling more than a few inches, so i believe its in park.
i had to tap the top connector into this for it to sit. after tryign to start the truck with no luck, i unplugged both connectors to make sure none of the pins were bent. none were, tried to put the connectors back in and they wouldnt go, so i pulled the weather connector out and tried, i got them back in without tapping. think i messed this thing up? anyway i can check this, make sure the adjustment is right? when i put the truck in park, it does unlock the doors and stops the truck from rolling more than a few inches, so i believe its in park.
#10
Check the ground on the back of the block by the top trans bolt , also check the curcit fuses under the hood the should be green 25 with A clear lens ! I didnt disconect the power and blew them