mitchellmade

iTrader: (13)

i swear its only a 30 spline out put shaft after i took off the transfer case (it was a very long day but Ill go count again tomorrow) pic posted is the sticker on the side of the trans help please?!

sleeperlqx

iTrader: (3)

where on the trans is it located? do you have a full pic of the trans?

here is 1 of my pics. the 60e is on the left. and the 80e is on the right. The tags are in different locations.

mitchellmade

iTrader: (13)

its a six speed from a 2008 sierra its behind a ly6 im trying to figure out if its a 80or 90e I just double checked its 29 spline here is a pic

onebad03

iTrader: (13)

im pretty sure the 90's were only in 3/4 tons and up and the 80's are in 1/2 ton platforms.

mitchellmade

iTrader: (13)

I need to find measurements that are known to be correct, I haven't found two overall measurements to be the same .would like to know length with or without bellhousing 4wd unit

onebad03

iTrader: (13)

im getting right about 47" from bellhousing to end of transfer case in an 08' AWD Denali. i say "about" because it was the closest i could get measuring around stuff. I measure the transfer case as "about" 23.5" so that makes the transmission "about" 23.5" as well.

onebad03

iTrader: (13)

This came off of a TBSS forum:

AWD/4WD Transmission-bellhousing to end of output shaft (bellhousing to end of case)
4L70: 26.875" (22.25")
6L80: 27.125" [+.250"] (23.3")
6L90: 28.625" [+1.750"] (24.7")
4L80: 29" [2.125"] (26")

midevil1

iTrader: (17)

You have a 6L80E.

1994Vmax

iTrader: (4)

Wrong, he does not.

It's a 6L90E from an LY6 powered 2500HD. The 2500HD pickup trucks never came with a 6L80E. The glove box RPO code will be MYD for that transmission. 8DKA is a GM identifier for a 6L90E.

midevil1

iTrader: (17)

with a 29 spline output shaft??? NEVER seen a 90 with the smaller output shaft. Didn't know they made a 2500HD AWD setup either... Somebody was throwing stuff together that week.