3" Stainless resonators
#32
TECH Junkie
iTrader: (8)
Join Date: Jul 2006
Location: OK
Posts: 3,895
Likes: 0
Received 0 Likes
on
0 Posts
I posted this over here too
https://www.performancetrucks.net/fo...81#post3616381
Not very happy. My first impressions on the cone after I installed it in the end of the y-pipe where it bolts to the rest of the exhaust are not good. I only went for a short drive but so far I noticed very little difference, sounds almost the same maybe a very slight improvement. I'm not ready to give up on it just yet though, I am thinking about trying to install it after the muffler this weekend. I was going to try to put it there tonight but I couldn't get the pipe loose from the muffler. Any suggestions on how to get the pipe loose from the muffler without hacking it up?
https://www.performancetrucks.net/fo...81#post3616381
Not very happy. My first impressions on the cone after I installed it in the end of the y-pipe where it bolts to the rest of the exhaust are not good. I only went for a short drive but so far I noticed very little difference, sounds almost the same maybe a very slight improvement. I'm not ready to give up on it just yet though, I am thinking about trying to install it after the muffler this weekend. I was going to try to put it there tonight but I couldn't get the pipe loose from the muffler. Any suggestions on how to get the pipe loose from the muffler without hacking it up?
#35
TECH Junkie
iTrader: (8)
Join Date: Jul 2006
Location: OK
Posts: 3,895
Likes: 0
Received 0 Likes
on
0 Posts
Those are made by Allens Stainless Exhaust. I ordered one of them for $44 shipped and it is all Stainless Steel. I believe they can make them in whatever length you desire.
What does the inside of a Dynomax bullet look like, is it similar to these? I chose this over the Dynomax mainly because it is stainless like the rest of my exhaust. I hope it does the trick.
What does the inside of a Dynomax bullet look like, is it similar to these? I chose this over the Dynomax mainly because it is stainless like the rest of my exhaust. I hope it does the trick.
#36
TECH Resident
Thread Starter
iTrader: (3)
Join Date: May 2005
Posts: 889
Likes: 0
Received 0 Likes
on
0 Posts
Very cool. Get some sound clips!
Althought I would have probably gotten one with at least an 18" body due to the resonance issue. I'd love to hear how yours is, though. Get them up!
Althought I would have probably gotten one with at least an 18" body due to the resonance issue. I'd love to hear how yours is, though. Get them up!
Last edited by ramdaspadhye; 04-25-2007 at 05:37 PM.
#37
TECH Junkie
iTrader: (8)
Join Date: Jul 2006
Location: OK
Posts: 3,895
Likes: 0
Received 0 Likes
on
0 Posts
I'll try I wish I had something better to record sound with than my phone. I think my wife's mp3 player will record sound maybe it will have better quality. I just ordered the resonator today so I unless it gets shipped super fast I probably won't get to install it until next weekend.