5.3 Head work
03-09-2004, 04:24 PM
#1
5.3 Head work
I am getting ready to send my heads off to get them ported and polished and hopefully milled .30 to get my comp around 11-1. And get something like 2.02 valves and such put in. Heads are going to be going on an LS1 and I am going to shove a 231/237 59x/6xx 
cam in it. Going to go N/A as well.
I was wondering where I should look to get this head work done, and I mean done right! Without paying overboard for it.
Thanks for any advice!
cam in it. Going to go N/A as well. I was wondering where I should look to get this head work done, and I mean done right! Without paying overboard for it.
Thanks for any advice!
03-09-2004, 11:42 PM
#3
Launching!
Join Date: May 2003
Location: Auburn, Nebraska
Posts: 230
Likes: 0
Received 0 Likes
on
0 Posts
Hey Tom this is where i had my heads done for my car.
http://www.totalengineairflow.com/services/index.htm
They are really good but somewhat pricey.
There is someone local in lincoln that does that too. It Waldron Machine across from Pro Tint on O street does head porting too.
Not sure if that helps ya.
http://www.totalengineairflow.com/services/index.htm
They are really good but somewhat pricey.
There is someone local in lincoln that does that too. It Waldron Machine across from Pro Tint on O street does head porting too.
Not sure if that helps ya.
Thread
Thread Starter
Forum
Replies
Last Post
07NBSChevy
GM Engine & Exhaust Performance
20
07-08-2015 07:27 PM
