Anyone had experience with these heads ??
#1
TECH Addict
Thread Starter
Anyone had experience with these heads ??
LS1 CNC Ported Showroom Stock Assembled Aluminum Cylinder Heads...PN 25534321....$1,379.00 ($689.50 ea)
these are available from Scoggin Dickey and look pretty killer...CNC ported w/63cc chambers, 2.00/1.55 valves and LS6 springs installed.....supposedly good for 25hp as a direct bolt-on for LS1/LS6
anyone know how these would flow compared to a mildly ported 6.0 head ??....my guess is better
these are available from Scoggin Dickey and look pretty killer...CNC ported w/63cc chambers, 2.00/1.55 valves and LS6 springs installed.....supposedly good for 25hp as a direct bolt-on for LS1/LS6
anyone know how these would flow compared to a mildly ported 6.0 head ??....my guess is better
#2
TECH Addict
iTrader: (1)
Re: Anyone had experience with these heads ??
If I remember correctly, these are milled pretty far to bump up compression ratio. A bunch of guys have called Lingenfelter (the ones who port them) and asked if they could get any with porting but without being milled. They said all of them are milled...I wish they weren't b/c I would be running those by now
EDIT: I think I was talking about the ASA LS6 heads...not sure if the ones you mentioned are the same?
EDIT: I think I was talking about the ASA LS6 heads...not sure if the ones you mentioned are the same?
#3
TECH Addict
Thread Starter
Re: Anyone had experience with these heads ??
The ASA heads that are ported by Lingenfelter are different heads ...these are GM Showroom Stockers, they are GM castings and are ported and milled by GM to meet Showroom Stock SCCA requirements
Thread
Thread Starter
Forum
Replies
Last Post
RedDeadG8
GMT 800 & Older GM General Discussion
26
12-01-2015 11:32 AM
sauldgold
GM Engine & Exhaust Performance
3
07-23-2015 02:15 PM