comp 918's good?
#13
Formerly darynC-10/23/10
Thread Starter
iTrader: (19)
Join Date: Aug 2006
Location: gonzales louisiana
Posts: 2,300
Likes: 0
Received 0 Likes
on
0 Posts
it was a futral f5. nowhere near the max out point... i hope all thats messed up is just the valve.... it didnt drop. its still in the guide. im going to wait till this evening to pull the heads , to damn hot......
hope it didnt warp my head
while they are off i guess i might as well port them and some thin cometics
hope it didnt warp my head
while they are off i guess i might as well port them and some thin cometics
#14
TECH Junkie
iTrader: (31)
Everyone pisses and moans about the new springs since there's been a few broken ones. What everyone fails to post up is their true installed height and that if they checked for coil bind. Everyone just thinks you can install a spring and run with it. Doesn't always work that way.......
#15
TECH Fanatic
iTrader: (16)
Join Date: Oct 2006
Location: Currently In suspense.
Posts: 1,783
Likes: 0
Received 0 Likes
on
0 Posts
Everyone pisses and moans about the new springs since there's been a few broken ones. What everyone fails to post up is their true installed height and that if they checked for coil bind. Everyone just thinks you can install a spring and run with it. Doesn't always work that way.......
You are right checking installed height and spring pressure is good practice.
What about the same type of people running PAC Beehives.I haven't read one failure report yet not saying its never happened just haven't read about it.
Thread
Thread Starter
Forum
Replies
Last Post
07NBSChevy
GM Engine & Exhaust Performance
20
07-08-2015 07:27 PM