Hit Man X

Okay I hacked that tube running into the intake and now have a quick question about the block off plate...

How large of a hole should I begin with inorder not to set an SES light?

Thanks!

Yelo

I think it's like 1/8th or 3/16th....no smaller

Hit Man X

Excellent! Thanks.

CashDudeHomie

iTrader: (5)

Where do you get that sheet gasket stuff? Did you just cut a 1/8 hole in the gasket itself or did you use a metal plate and 2 pieces of gasket?

Hit Man X

I used a metal plate between that gasket stuff. I picked it up at O'Reilly and any auto parts store should carry that gasket stuff.

The 1/8" hole was too small and threw an SES light last night. I drilled the hole to 3/16" and heopefully it will be okay.

Does anyone know if the light will reset itself I do I need to go clear it with AutoTap?

BigKID

iTrader: (5)

If the second hole is big enough and the pcm deems everything OK it will eventually clear itself after so many cycles. But since you have atap I would go ahead and clear it.
btw.. a buddy had to go to a 5/32 in his.

YUKONTURTLE

Do you know what the DTC code was? I would reset the code instead of waiting for it to clear.

Hit Man X

I just went ahead and disconnected the batt as I can't get my damn USB->Serial adapter to work with this damn laptop from work! I guess it is too new.

I need to get an old cheapass laptop for DTC and EDIT.

Any ideas on how long it takes to reset after the batt is disconnected?

1BADHD

Couple minutes. I thought you had to pull a fuse or two also.

Hit Man X

Well damn I hope I don't have to pull any fuses! lol.

Well, we shall see after lunch here hopefully all will be okay otherwise I will have to tote my desktop out to the garage and clear it!