electronic tb to cable driven?
02-27-2010 | 06:32 PM
#12
I'm not familiar with anyone doing this, but along with having to change the TB, re-tune the PCM, and change the wiring to the TPS and IAC, you'll need a different gas pedal.
03-05-2010 | 07:22 PM
#13
I don't see where to mount the bracket for a the cable on the dbw intake? Does anyone have a pic of one? I am looking to use a truck intake on a car since these are supposed to perform close to an ls6 manifold, and I have the hood clearance and really could use the money elsewhere.
03-06-2010 | 06:22 PM
#14
I don't see where to mount the bracket for a the cable on the dbw intake? Does anyone have a pic of one? I am looking to use a truck intake on a car since these are supposed to perform close to an ls6 manifold, and I have the hood clearance and really could use the money elsewhere.
03-07-2010 | 12:38 PM
#15
I don't see where to mount the bracket for a the cable on the dbw intake? Does anyone have a pic of one? I am looking to use a truck intake on a car since these are supposed to perform close to an ls6 manifold, and I have the hood clearance and really could use the money elsewhere.
08-21-2010 | 04:13 PM
#16
Couldn't a person just pin out the Electronic TB PCM to match the Cable TB PCM and go from there? The Electronic PCM is passing signals to the Throttle Control Module which is then controlling the TB.
08-24-2010 | 02:08 AM
#17
Thread
Thread Starter
Forum
Replies
Last Post
drummer0415
GMT 900 Trucks General Discussion
11
10-24-2015 08:16 PM
rednekferlife101
GMT 900 Trucks General Discussion
5
09-14-2015 05:27 PM
