Flyer

iTrader: (1)

My TOG's didn;t move the cats at all. They have you cut the pipe about an inch in front of the cats, and weld the collectors up at the cut. My Y-pipe hasn't been touched behind the cats.

If it weren't raining out .. I would offer to grab a pic of the CARB sticker, but it's cold and wet.

Fun Guy

So they're shorties then. That makes sense, since it's only shorties that can get CARB stickers.

Flyer

iTrader: (1)

no .. they aren't shorties ...

This is on the old truck from the underside
http://bettie.homeip.net/atvpics/tru...t/100_0483.JPG
http://bettie.homeip.net/atvpics/tru...t/100_0485.JPG

These are them on the floor after getting coated
http://bettie.homeip.net/atvpics/tru...t/100_0576.JPG

And installed from the top
http://bettie.homeip.net/atvpics/tru...s/100_0581.JPG
http://bettie.homeip.net/atvpics/tru...s/100_0582.JPG

You can see part of the CARB sticker in this shot .. you can make out the end of Guys on the oval sticker just ouf of the picture on top of the airbox.
http://bettie.homeip.net/atvpics/tru...X/100_0672.JPG

Shorties are true bolt ons. They don't require welding to be installed. They bolt up where the manifolds bolot up.

Fun Guy

Hmm, very interesting. I stand corrected. What is that connector (welded shut it looks like) coming off the one header in this picture? http://bettie.homeip.net/atvpics/tru...s/100_0581.JPG

Flyer

iTrader: (1)

EGR provisions ... 02 and up dont have it .. so I had it welded shut.

Fun Guy

Interesting. Do you have before and after dynos runs? What kind of gains did you see, do you know?

Flyer

iTrader: (1)

No dyno runs ... It's not a dyno queen .. sry. I could tell a big difference in them after the headers went on the new truck. I did to much at one time on the other one to know if they made a difference or not.