Fbody LTs on Truck = Tons of Cutting
#32
10 Second Truck Club
iTrader: (22)
Sure throw me into the fire.
Here is the biggest problem I am running into. The material costing just to start the project is making the pipes cost not end-user freindly. Stainless is not cheap, maybe need to be carbon then coated.
But I will admitt, I am confused from reading this thread.
Is there headers out there with 1 7/8 tubes or larger for these trucks.?
Here is the biggest problem I am running into. The material costing just to start the project is making the pipes cost not end-user freindly. Stainless is not cheap, maybe need to be carbon then coated.
But I will admitt, I am confused from reading this thread.
Is there headers out there with 1 7/8 tubes or larger for these trucks.?
#35
TECH Fanatic
iTrader: (7)
Join Date: Jul 2002
Location: RGV, Texas
Posts: 1,482
Likes: 0
Received 0 Likes
on
0 Posts
i just tested some Kooks on my truck, the drivers side was ok, but was facing to much to the outside, the passenger was hitting the tranny lines, would need to redo those and was very close to the frame, i just wish a company would do 1 7/8 headers for us.
Thread
Thread Starter
Forum
Replies
Last Post
banker099
TECHNICAL WRITE-UPS
0
07-04-2015 05:50 PM