Atomic

iTrader: (42)

I have a ball and socket setup, made by flowmaster, off the headers, and then just a regular 3-bolt flange welded to the other end of the mid pipe. I can remove the sections off the headers to behind the trans crossmember if I need to.

oldred95

I like the looks of the 3 bolt flanges. Where did you come up with those at?

Atomic

iTrader: (42)

I bought them from summit, try to get thick ones so they don't warp when they are welded

oldred95

Unless I'm looking in the wrong section I don't see anything for 4 inch pipe.

Atomic

iTrader: (42)

Oh, those parts are 3", I have 4" off the last muffler and its the pre-made pipe.

oldred95

I could always make my own out of some 1/4 inch plate but that may be more work then its worth. I could even do a slip together pipe joint and a band clamp for that matter.


Ha found one on ebay.

http://cgi.ebay.com/ebaymotors/FLANG...Q5fAccessories

Looks to be 10 bucks per flange so it will take two but still thats not bad for the amount of time it would save. A piece of plate big enough to cut two flanges out of would probably cost at least 10 bucks.