hankd

Wasn't too bad...if I was to do it again, I'd say 30-45 minutes easy...

With a 2 jaw gear puller, it's cakework (we also used a large C-clamp to take some of the load off the puller as we cranked on the keys). Raised the front 1.5 inches and I haven't played with the torsion bar screws yet...they're back where they were to begin with (about 9-10 threads left)...

Before:

After (much better):

Those are the new BFG 285's too...

My wife drove the truck home and she said it didn't feel like it rode any rougher (take that for what it's worth...I'll drive and follow up).

Later

BigTex

iTrader: (16)

That makes a world of difference in the look on these things. I have min set to where the lower edge of the air dam is directly in line with the center of my front wheel.