home brew intake tube
#1
On The Tree
Thread Starter
Join Date: Sep 2004
Location: Stroudsburg, Pa
Posts: 184
Likes: 0
Received 0 Likes
on
0 Posts
home brew intake tube
since I got rid of my stock fan and shroud and went with the flexs I now have the need to improve upon the AIRAID's pancaked intake tube. It was great in that it allowed me to keep everything else in position but now it just looks dumb twisted and flatened where there is nothing to have to go around anymore. Im guessing theres a pony or two there to free up as well so my exhaust guy is bending me up a piece of 4'' that I will then send out to get jet-hotted sterling to match my headers that I just got back from them. I think it will accent and function well under the hood. what do you guys think? pics of your creations would be great if anybody else has done this....
I am also contemplating the new 90mm TB from B&K?
I am also contemplating the new 90mm TB from B&K?
#3
On The Tree
Thread Starter
Join Date: Sep 2004
Location: Stroudsburg, Pa
Posts: 184
Likes: 0
Received 0 Likes
on
0 Posts
pics will be posted. the dynatechs are getting installed now and he is going to take measurements while hes got the truck this week....
on a side note ive been reading a bunch of ill-fitting dynatech story posts tonite
on a side note ive been reading a bunch of ill-fitting dynatech story posts tonite
Thread
Thread Starter
Forum
Replies
Last Post
AHelm3
Dynamometer Results & Comparisons
3
04-08-2016 07:51 AM
BlackGMC
GM Parts Classifieds
12
08-17-2015 07:07 PM
05GMC4.8
GMT 900 Trucks General Discussion
5
08-07-2015 09:55 PM