blacksheep

iTrader: (1)

I'll be installing the injectors tomorrow and was looking for some help or advice. Is there any one who has done this and has some pictures? I'm not sure how to shim the injectors so that fit in the fuel rail or how to splice into the wires. Any help would be very much apreciated.

sleepersilverado

iTrader: (1)

Yes i can help you out. Give me your e-mail adress and i will go out now and shoot some pics for you. Ler me know.
Ryan

blacksheep

iTrader: (1)

Ryan my email is invspd@yahoo.com I apreciate it alot. Thanks, Curt

Slowverado

ryan, email me those pics also if you could, i'm gonna be doing my injector install in a week or so and woulnd't hurt to have the pics since i need all the help i can get.

Ryan23silverado

iTrader: (1)

Sorry to be jumping on the band wagon Ryan, but could you mail me those also? rcleary23@hotmail.com Much appreciated man.

OOsilverado

if u wouldnt mind helping out another ryan on the board, would you mind sending them this way as well, thanks

ryan

Ryan23silverado

iTrader: (1)

Hey Ryan (sleepersilverado Ryan ) I received the e-mail. Thanks man, those are some helpful pics. Just two questions. How long is each copper spacer? And, what wires did you have to cut and solder? Thanks again

Ryan

sleepersilverado

iTrader: (1)

The spacers were 5/8". The wires i soddered were the injector connectors. i unpluged the old from the injectors then pulled them out of the wire loom and cut them up there were you would not see it. i did this because the new connectors had long wires.
Ryan

Slowverado

where do you get the new connectors for the SVO injectors? and how do you space the fuel rail higher to accomidate the bigger injectors?

blacksheep

iTrader: (1)

Ryan I never received the pictures could you please send then again. Thanks