Intake/Throttle body problem
#1
TECH Veteran
Thread Starter
iTrader: (5)
Join Date: Aug 2004
Location: Alvin,TX
Posts: 4,123
Likes: 0
Received 0 Likes
on
0 Posts
Intake/Throttle body problem
I was switcing out my Ported TB back to my stocker this weekend. Was tightening the 3 nuts on the intake where the TB goes, and the top stud sheared and snapped. So now I am running with the TB held on by the 2 bottom bolts, It seems pretty tight and not running bad, at least not any worse than it has been, but I'm trying to figure out how to replace this. The stud doesn't go all the way through, I'm wondering if they are tap in studs that you can pull out and wedge another one in, or would I have to replace the entire intake?
#2
FormerVendor
iTrader: (6)
Join Date: Nov 2004
Location: BERRIEN CENTER,MICHIGAN
Posts: 1,017
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SierraCrew
I was switcing out my Ported TB back to my stocker this weekend. Was tightening the 3 nuts on the intake where the TB goes, and the top stud sheared and snapped. So now I am running with the TB held on by the 2 bottom bolts, It seems pretty tight and not running bad, at least not any worse than it has been, but I'm trying to figure out how to replace this. The stud doesn't go all the way through, I'm wondering if they are tap in studs that you can pull out and wedge another one in, or would I have to replace the entire intake?
Last edited by KLUG'S SS; 08-22-2005 at 10:28 AM.
#3
TECH Veteran
Thread Starter
iTrader: (5)
Join Date: Aug 2004
Location: Alvin,TX
Posts: 4,123
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, there is about a 1/2 inch of thread sticking out of the intake. I can definitely grab hold of it. It pretty much broke off flush with the lip on the TB unit. So where can I get another stud to thread into its place? The dealership?
#4
FormerVendor
iTrader: (6)
Join Date: Nov 2004
Location: BERRIEN CENTER,MICHIGAN
Posts: 1,017
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SierraCrew
Yeah, there is about a 1/2 inch of thread sticking out of the intake. I can definitely grab hold of it. It pretty much broke off flush with the lip on the TB unit. So where can I get another stud to thread into its place? The dealership?
Well at least you can grab ahold of it. Instead of the pliers you could always do the double nut trick on it. Thread two nuts onto the stud and tighten them back to back, this works pretty well for getting studs out also.
I would say that you will probably have to go to the dealership for the new stud.
#6
FormerVendor
iTrader: (6)
Join Date: Nov 2004
Location: BERRIEN CENTER,MICHIGAN
Posts: 1,017
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SierraCrew
Thanks for the help Klug. I'll try that and try to go by the dealership here just after work.