PerformanceTrucks.net Forums

Notices
GM Engine & Exhaust Performance EFI | GEN I/GEN II/GEN III/GEN IV Engines |Small Block | Big Block |

Long vs short cranks

Thread Tools
 
Search this Thread
 
Old 10-11-2011, 08:35 PM
  #1  
Launching!
Thread Starter
iTrader: (1)
 
Manbearpig's Avatar
 
Join Date: Sep 2008
Location: Midland, TX
Posts: 204
Likes: 0
Received 0 Likes on 0 Posts
Default Long vs short cranks
Are these long or short cranks?
Manbearpig is offline  
Reply Like
Old 10-11-2011, 08:57 PM
  #2  
TECH Senior Member
iTrader: (26)
 
kbracing96's Avatar
 
Join Date: Jul 2004
Location: Oakland, OR
Posts: 9,485
Received 30 Likes on 28 Posts
Default
Short, you can see where the seal was riding on them about an 1/8" from the edge. Long cranks are about a 1/4 longer then that.
kbracing96 is offline  
Reply Like
Old 10-11-2011, 09:11 PM
  #3  
Launching!
Thread Starter
iTrader: (1)
 
Manbearpig's Avatar
 
Join Date: Sep 2008
Location: Midland, TX
Posts: 204
Likes: 0
Received 0 Likes on 0 Posts
Default
Alright good

Last edited by Manbearpig; 06-09-2020 at 11:17 AM.
Manbearpig is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
short tubes vs. longtubes
too slow
GMT 800 & Older GM General Discussion
12
02-02-2011 06:08 PM
Intake Runners - Long vs Short
dirt track racer 81
GM Engine & Exhaust Performance
2
01-23-2009 04:54 PM
Shorties or long tubes?
fastgmc53
INTERNAL ENGINE MODIFICATIONS
18
02-12-2008 08:13 PM
Thorley tri-y vs. standard long tubes poll in side ( opinions welcome )
LVSTOGOFST2002
GM Engine & Exhaust Performance
18
10-17-2005 07:46 PM
shorties vs. long tube
RED2K
GM Engine & Exhaust Performance
4
07-29-2002 12:53 AM
Back to Subforum
GM Engine & Exhaust Performance
View Next Unread
sluggish after header install




Advanced Search
Quick Reply: Long vs short cranks


Reply Closed Thread Share

All times are GMT -5. The time now is 08:42 AM.