dirt track racer 81

iTrader: (45)

Very easy.. since the fbody water pump and the truck water pump have the same casing (except for the inlet pipe) and shaft, just take the pulley off your truck water pump and press it on the fbody water pump..belts line up perfectly, i havent set the intake on this yet, but i think it should work..

bluecajun5.3

iTrader: (31)

sweet.
keep us UTD.

dirt track racer 81

iTrader: (45)

ill get pics either tonight or tomarrow..aligned perfectly

Quik

iTrader: (7)

good if it works out for you that way

how about the clearence between the pulley and TB?

dirt track racer 81

iTrader: (45)

like i said in my first post i havent set the intake on it yet, but the diameter of the f-body and truck pullies are the same, and im using the f-body housing, so really there shouldnt be any issues.

v8

iTrader: (10)

umm, your idler pulley won't work in the stock location, you will also have to cut the bracket its held onto, you will either need to make a new bracket under the alternator or get the speartech one. good luck either way.

Quik

iTrader: (7)

i know my belt lenght is different then the truck belt i once had. i know my crank is smaller

dirt track racer 81

iTrader: (45)

yes the crank is smaller, I did compare them.

Okie5.3

iTrader: (1)

is yours the car or truck?

dirt track racer 81

iTrader: (45)

didnt think about that, I will look into that next time I get a chance to go look at it again..