Got my truck back yesterday and I got to say it's a total different truck! Had a cam installed and of course a tune. Here is the dyno run. Big thanks too RPM motorsports
https://www.youtube.com/watch?v=ZhFWfURyFQs

 

Good numbers.. Sound great!

 

full cam advance below 3500, slowly bring it back to a 4.5 degree at 7k in a 1.5 degee increment. this will give it a base vvt scaling to go off of. more torque! im just guessing it's a vvt cam though

 

I did the vvt delete. I plan on throwing a charger on top after a while.

 

ahh. add timing down low!

what cam?

 

227/239 .611 .624 115+3

 

What exhaust are you running? I'm building a LS3, out of a friends camaro, with a L92 intake, ported/polished LS3 heads and Airaid CIA intake for my '08 Suburban. Looking for shorties and a cat back exhaust to finish it off. I have a '10 SS/RS making 498RWH NA. The Burb is being built for torque over horsepower to pull my boat and camaro.

 

Kooks longtubes with there cat connection with x pipe with no mufflers. All three inch pipe. Its crazy loud but pretty mellow with that xpipe.