Need some info on milling 243s....
#1
Staging Lane
Thread Starter
Need some info on milling 243s....
Ok guys so i'm getting ready to mill my 243s what mill would be safe to get close to 56cc?
I got told to do a .055 mill but not sure if it would be safe...Dont want to run into intake alignment problems...Btw the heads will go on a 2010 4.8
I got told to do a .055 mill but not sure if it would be safe...Dont want to run into intake alignment problems...Btw the heads will go on a 2010 4.8
#3
Staging Lane
Thread Starter
#7
11 Second Club
iTrader: (6)
Join Date: Feb 2005
Location: middle of nowhere, Kansas
Posts: 1,401
Likes: 0
Received 5 Likes
on
5 Posts
I have to agree, .030" is about the safe limit for 243 heads. Flycutting the pistons might help with valve to piston clearance, but it also increases the compression ratio too. So, it seem rather counter-productive with what you want to accomplish.
Thread
Thread Starter
Forum
Replies
Last Post
someotherguy
STEREO & ELECTRONICS
10
10-05-2015 12:49 PM
gmcyukon
GM Parts Classifieds
6
10-03-2015 11:03 PM