st_jfeist

heard the radio where you from in texas.

BigTex

iTrader: (16)

I had good success with the aluminum gaskets as well until I installed a Radix. I had plenty of leaking 3-bolt gaskets until I found the aluminum ones. They held up for fine for N/A and occasional spray. But shortly after installing the Radix (and running it hard), I developed another gasket leak. When I pulled it apart, I think I found the melting point of aluminum :

BlackGMC

iTrader: (31)

Dear lord, that is one messed up gasket... I am hoping these V-bands work out, I have only driven the truck to the store and back, it is running pig rich, due to the previous headers leaking and throwing off my Wideband...

southern_chevy

iTrader: (9)

Hey so how are those V-clamps working for ya? I have a leak started where it bolts up to my headers and I need a place to disconnect the back half of my exhaust. So when you going to make a few of those Y pipes to sell? I will be first in line. lol

BlackGMC

iTrader: (31)

the V-bands are working out really good. It makes droping the Y-pipe so much easier... I only drove with the new setup long enough to roughly tune the truck, then I took the headers off to get them recoated...

1FUNZ71

I need mine done.. I just need an x pipe and spintechs with a turn down. Let me know if you interested on teaching some exhaust fab.

BlackGMC

iTrader: (31)

Can you weld?

Formula96

hey blackgmc, you ever run over to longview? i would like to see that truck in person...

BlackGMC

iTrader: (31)

hmmm, not really, I usually just stay on the west side of fort worth... If you ever on this side of town give me a PM and we could meet up or something... I might be planning a PT.net GTG at my house in a few weeks....

SimpleManLance

iTrader: (9)

dang corey, your not messing around. that craftmanship looks great. the truck sounds good too.