Kelly Timoffee

.....

arthursc2

iTrader: (5)

I have some photos of how I did that floating around. I did it with a single 3.5"

I'll see if I can find them

Kelly Timoffee

.....

arthursc2

iTrader: (5)

lol

do a tuned dyno pull before and after, then get an RMA from them

wretched73

iTrader: (1)

I used Ebay special, 304ss 1 7/8" x 3" headers and 3" Y pipe. I think I paid $250 delivered to NJ.

I have more than enough low end to spin the tires

Kelly Timoffee

......

terravast4

iTrader: (25)

holy ****. Thats a waste if $479.

arthursc2

iTrader: (5)

You wont see any gain with them, that was my point. If you're happy with the purchase have at it, but shorties are proven to not provide any gain over stock manifolds

Kelly Timoffee

......

RedXray

Sometimes I just don't understand people. This forum is by far is the most informative resource for GM performance trucks anywhere on the planet. We here give the best information we've learned as a collective with many many decades of experience. I've been wrenching on hotrods going on 50 years myself. When I seek information on questions I may have... I weigh the replies along with my knowledge come up with the best outcome. Why even ask the questions when going in someones mind is dead set and unvarying?