Z284thgen

iTrader: (46)

now i just wish my dyno shop that is 1.5 miles from the house was open so i could have some new numbers

and no poking fun at how i got the rear 02's zip tied up and hanging in the breeze thats just temp tell i can get over to ed wright and get them turned off as well as the EGR

Sport Side

iTrader: (6)

The exhaust system looks great. Someone did a top notch job on those bends.

Z284thgen

iTrader: (46)

the shop that did it is really really well known for there good work. his two guys have worked there for over 7 yrs that i can remember since i been using them. i was kinda worried about going over the tranny crossmember on the DS cause of all the fuel lines and crap but he made it work so im happy with them once again

Sport Side

iTrader: (6)

Yeah, you can definetly tell they have some experience. What size tubes?

Z284thgen

iTrader: (46)

all 2.5 from collector back until new motor is built then i will step up and build a mandrel bent 3" but at my rate it will be a couple yrs

fluxu8

Good pics....but for some reason I can't hear anything.....I need more cowbell! or I'd settle for a video.

SimpleManLance

iTrader: (9)

looks great. nice and clean.

looks to me like us 4wd guys are going to be SOL on these headers. look how close that is to the transmission i doubt a drive shaft will fit in that gap.

1slow01Z71

iTrader: (36)

Well I will soon see.

Dros44ss

Those look real nice. I have a 2003 silverado ss. And I used TOG headers. And I loved the diffrence between them and the stockers. And by the way your car sounds amazing.

Z284thgen

iTrader: (46)

thanks guys as far as a video it will have to wait until i get back from Borger Tx as im now in the best western with out my truck as i will be here for work for the next week or so