Ported Throttle Body Problems???
#1
Ported Throttle Body Problems???
I ported and half-shaft a throttle body for my 05 6.0. I was careful not to port where the blade rests. When I started the truck, it revved up to 2500-2700, fell, and idled... It does this everytime. Also, when you give it throttle, it acts like it sticks and slowly revs down. Alot slower than normal. Sometimes it idles fine, sometimes it slightly surges. Is this normal and will it go away? Or did I screw something up?
#2
TECH Apprentice
iTrader: (11)
Join Date: Jan 2008
Location: Lubbock Texas
Posts: 366
Likes: 0
Received 0 Likes
on
0 Posts
+1 I just gave mine a tiny port job, I removed that lump on the lower part, and just polished the rest, and mine is saying Reduced Engine Power. I also marked where the blade was. I didnt cut the shaft.
Last edited by Modern_Muscle; 10-04-2008 at 04:46 PM.