chevyguy7802

iTrader: (3)

How do you guys think the tr220 would perform in the 6.0? When I took
the stock 6.0 out to the track it ran a 8.7 (1/8) in the heat. The only mods are ls6 intake,cai,lt's,3k stall,and 4:10s. I really want to stay with a smallish
cam with this motor, let me know what you guys think!

joeyc125

iTrader: (7)

its great in my truck, power pulls to around 6200, and in od and tc locked at 1700 rpm i can give it a little gas without unlocking the tc and gain speed pretty easily.

02_Orange_D1SC

iTrader: (30)

id say either a TR-220 or a TR-224 would be a good cam with the stall your running what happen to your old iron LS1?

chevyguy7802

iTrader: (3)

Yea im just wantin to try out a small cam. I just took it apart a couple weeks ago and it turned out to be a spun rod bearing, itll be a quick fix I just think im gonna use it for another project.

fastrt

iTrader: (48)

I will give you my low mile tr224/112 if you get me a good used tsp 224r/112. pm me

Tootall

iTrader: (79)

I ran a 222/224 566 568 -112 for a while in a stock headed 6.0 with no stall and I loved it

chevyguy7802

iTrader: (3)

I'll think about it! How are you likin the tr224 in your 5.3?

Yea ive thought about that cam too, how much rpm would it pull with your
setup?

00ChevyScott

iTrader: (10)

David (dlt76028) is running a TSP 224 XE, and has had GREAT results.

Tootall

iTrader: (79)

shift points were 6300 and 6000 . . . pulled all the way

It was more for bottom end torque. I could stomp just about anything from a dead stop to 3rd gear

again, there are better ones out there. I've done several swaps with the low and high lift 212/218. Its an all around cam

LsxCody

iTrader: (3)

I would think a 220 cam would make good power in you're motor