SILVERBIRCH

iTrader: (1)

Well I think I must start adding a little help to my transmission after adding the Cam and Long Tubes I would like to have a peace in mind so I was thinking of adding a Tru-cool 40,000 Trans cooler along with a Hughes Deep Aluminum Trans. Pan. I know many of you guys run one of these I would like to get some feed back on them. Do you guys think this should be sufficient with the mods i have listed in my Sig.

Thanks!!!

SILVERBIRCH

iTrader: (1)

Moderators please move to proper section I wasnt paying attention my bad!!!

04SilveradoMykk

I've got a Tru-Cool mini-max & Derale deep pan with cooling tubes on my '04 4L60E, I also wrapped the exhaust pipe going under the trans pan with header wrap and used royal purple syn trans fluid

Before, my stall converter used to cook the trans fluid so much you could smell it in the cab. Now my trans temps have not gone above 135 degrees, and usually cruise around town @ 128-130, and I could probably do better if I mount the cooler in front of the Efans too

lablackbeast

iTrader: (5)

were can i get the 40,000 trans cooler???

budhayes3

iTrader: (19)

I think that a lot of guys get them on ebay...search TruCool 40K...(maybe oregonperformance.com also)

xlcooplx

iTrader: (26)

my 40k GVW cooler keeps my trans really cool....so cool that i wouldn't even consider an aftermarket pan

budhayes3

iTrader: (19)

Yea, the factory deep pan is pretty good...I like some of the aftermarket pans such as the B&M and Hughes, but it appears that clearance would be tight with my y-pipe....

lucky77

iTrader: (4)

tru-cool 40k should do the job.. no need for a deep pan. instead of the deep pan... get a shift kit+servos . they should beef up the tranny.

SILVERBIRCH

iTrader: (1)

Thanks for the advice guys

BigRedChvy355

iTrader: (4)

+2 on the shift kit/servos.