scooter k

iTrader: (22)

It bolts to the trans. They wouldn't bolt to the body because that would transmit noise. I have only seen those on a 4L80 that uses the factory dual inlet muffler.

zeake

iTrader: (5)

My RCSB does not have this. It is usually on a 2500hd bolted to the transmission.

BadAssChevy327

iTrader: (7)

well my 4l65e SSS has it. i believe any 6.0 factory truck has it. it just holds the slip fit and bolt up one. its a smart design everything moves with each other

hirdlej

iTrader: (31)

Right, so since they made regular cab 6.0l trucks (2500 series) I'm sure there's a provision in the cab to bolt this hangar on, correct?

BadAssChevy327

iTrader: (7)

it bolts to the tranny. end of story. but they did make 6.0's with 5 speeds. in the 2500 hd. so i dont see a reason why it wont work.. or if not you can find one off a 5 speed one.

1Bear

iTrader: (1)

There are various mounts for the different transmisions that were available with the 6.0 & 8.1L engines with dual exhaust pipes. You just need to pick the correct style for the transmission and exhaust configuration you have. I believe I got the designations right, but one would be prudent to verify before ordering anything.

4L60 Mount

4L80 Mount

(RPO) MT1 C5F/C6P Mount

(RPO) MW3/C6P Mount

(RPO) ML6 Mount

(RPO) M74 Mount

zachm89

iTrader: (16)

it goes up over the crossmember and bolts to the side of the trans just like the image above of the 80e. i pulled mine off when i got my exhaust redone because they put other hangers on instead.

hirdlej

iTrader: (31)

Arrr har har!!!! I like the pics! Livesaver. I'm going to go see if there's a provision on my trans that would allow me to use the 6 speed manual bracket

budhayes3

iTrader: (19)

Yessirreee, good job 1Bear, those pics cleared it up for sure Now I see how it goes...the pic in Joe's first post is deceiving