I have a Chevy 6.0 L " LQ4 " Vortec engine from a 2002 Chevrolet Suburban with only 38k miles, that was going to be used for a project, but will not be done any longer

The engine is complete from intake manifold to oil pan, with exception of throttle body, accessories and all wiring and pcm

It has the coil packs w/ brackets & harnesses (needs two coils though) Intake manifold with injectors & rails, map sensor, cam & crank sensors, coolant crossover tubes , water pump, complete stock long block with stock #317 cylinder heads, Vortec top engine cover

This is a Gen III engine with a 24x reluctor wheel

Asking SOLD

call/ text/ pm (702)677-4085

in Las Vegas zip 89123

 

Sell just the short block?

 

possibly?

Where are you located? indiana or vegas?

What were you thinking?

thanks, Jeff

 

Vegas rite now

what else ya got layin around besides the stuff in the other thread?

 

not that much right now! Work is slow, so I sold off a bunch of stuff after I built the 6.0L for the sand rail!

just sold a complete LS1

Just have the complete LS1 shortblock w/ cyl. heads, pushrods, valve covers, and truck intake setup if wanted for free
and a blown LS1 block & f-body oin pan all just for mockup use

Feel free to give me a call and stop by! (702)677-4085

thanks, Jeff

 

new engine in the sand rail!

 

Bump for a good seller
Did the cam I sold you go in the sand rail?

 

Yes it did!!

thanks again!

 

God damn on the other side of the country

 

bump it up