6 liter short block
12-12-2009, 12:45 AM
#1
SPAM HUNTER
Thread Starter
iTrader: (19)
Join Date: Jan 2004
Location: NM
Posts: 4,099
Likes: 0
Received 0 Likes
on
0 Posts
6 liter short block
Gen IV LY6 Block
Stock crank, has 24x reluctor wheel installed (was done at scoggin dickey in lubbock tx)
stock rods (same as ls2)
NEW 6 liter flat top pistons and rings
New ls2 front cover and sensor with harness and gasket and bolts
New 1x cam gear and tensioner
Rear cover, and valley cover included with gaskets and bolts
Block side holes have been drilled and tapped to allow gen III knock sensors to be used.
THIS IS THE LOWEST PRICE I WILL TAKE!
THERE IS NO CAM OR LIFTERS!
DO NOT PM ME UNLESS YOU HAVE A TRADE OFFER OR YOU WANT MY PAYPAL NAME!
1200 plus shipping. (quotes so far about been about 300)
UPDATED PICTURES: Got the pump and front cover installed, valley cover, and finished up the GEN III knock sensor conversion.
Stock crank, has 24x reluctor wheel installed (was done at scoggin dickey in lubbock tx)
stock rods (same as ls2)
NEW 6 liter flat top pistons and rings
New ls2 front cover and sensor with harness and gasket and bolts
New 1x cam gear and tensioner
Rear cover, and valley cover included with gaskets and bolts
Block side holes have been drilled and tapped to allow gen III knock sensors to be used.
THIS IS THE LOWEST PRICE I WILL TAKE!
THERE IS NO CAM OR LIFTERS!
DO NOT PM ME UNLESS YOU HAVE A TRADE OFFER OR YOU WANT MY PAYPAL NAME!
1200 plus shipping. (quotes so far about been about 300)
UPDATED PICTURES: Got the pump and front cover installed, valley cover, and finished up the GEN III knock sensor conversion.
Last edited by 2005 Silverado; 02-07-2010 at 08:08 PM.
12-12-2009, 01:07 AM
#3
SPAM HUNTER
Thread Starter
iTrader: (19)
Join Date: Jan 2004
Location: NM
Posts: 4,099
Likes: 0
Received 0 Likes
on
0 Posts
20 aps out and nothing catching for work right now...i have to pay bills. The 80e will stay, the 5 speed sucks and i would rather have a transmission to back up a going one, then a motor to replace a good running one...you know what i mean?
