Cal Speed headers clearanced for 4x4.
#1
TECH Resident
Thread Starter
iTrader: (7)
Join Date: Mar 2004
Posts: 888
Likes: 0
Received 0 Likes
on
0 Posts
Cal Speed headers clearanced for 4x4.
SOLD
Abridged version.
Calspeed 1 3/4" SS headers clearanced for a 4x4 with Y-pipe. Upgraded clamps.
$300+shipping.
I had a set of Cal Speed 1 3/4" SS headers and Y on my 06' Silverado Z71. I spent A LOT of time clearancing them to fit with out much wasted "clearancing" They will bolt right up now. I ordered them with the upgraded band clamps. I traded in the truck and the dealership asked me to return it back to stock a couple weeks later. So now I have the headers and Y-pipe sitting in my garage. They were on the truck for a thousand or so miles. The worked great, fit perfectly now and made good power. Looking to get $300+shipping for them. PM me if you are interested.
Abridged version.
Calspeed 1 3/4" SS headers clearanced for a 4x4 with Y-pipe. Upgraded clamps.
$300+shipping.
I had a set of Cal Speed 1 3/4" SS headers and Y on my 06' Silverado Z71. I spent A LOT of time clearancing them to fit with out much wasted "clearancing" They will bolt right up now. I ordered them with the upgraded band clamps. I traded in the truck and the dealership asked me to return it back to stock a couple weeks later. So now I have the headers and Y-pipe sitting in my garage. They were on the truck for a thousand or so miles. The worked great, fit perfectly now and made good power. Looking to get $300+shipping for them. PM me if you are interested.
Last edited by Pray; 05-11-2012 at 06:42 PM.
#7
TECH Resident
Thread Starter
iTrader: (7)
Join Date: Mar 2004
Posts: 888
Likes: 0
Received 0 Likes
on
0 Posts
Trust me. It is worth it not to have to do the clearancing and cutting by your self. These things are stainless steel and it wasn't easy. I basically had to dimple the #1 primary by the steering shaft. Then clearance the three inner primary pipes to clear the front drive shaft and U-joint. I had to clearance and cut the Y-pipe to make it fit around the drive shaft and clear the Trans cross member. I also had to cut the D side collector to get the Ypipe to fit on far enough so it wouldn't **** sideways and not clear the tranni cross member also. I will send pics to email address for those that ask. These things still made 15-20rw at least considering I gained 43/30rw I believe with doing a light clean up/port job on the heads and adding the headers at the same time. If this company made TBSS headers I would buy anothe set.
They will be boxed up and ready to ship tonight. I can get them out tomorrow.
They will be boxed up and ready to ship tonight. I can get them out tomorrow.
Last edited by Pray; 05-11-2012 at 03:14 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
zblee
GM Engine & Exhaust Performance
63
06-10-2023 01:25 PM
ARC
GMT 800 & Older GM General Discussion
57
02-21-2022 10:54 AM