I just recently uninstalled my Spintech muffler and turndown tips due to wanting a different exhaust setup. Here is whats for sale:

1.) Spintech 8436 Truck/RV Series Muffler
SpinTech Truck / RV 8000 Series - Mufflers - Street Mufflers - 8000 TRUCK/RV MUFFLER SERIES - SpinTech Performance Mufflers

This muffler has a Center 3" inlet to dual 2.5" Exits. The case size measures 4x10.5.20. I had Ron at Spintech custom build this muffler for me using all 304 Stainless Steel. To further protect it from the elements and surface rusting here in lovely Upstate New York, I spray painted it using VHT Flame Proof Ceramic Coating. The coating held up great and only got dirty. I did respray a fresh coat on all the parts after uninstalling them just to clean them up a bit. I ran this muffler on my truck without the factory resonator. I imagine if one were to run it using resonators/smaller mufflers further down the system that it would be a bit louder than stock. When I ran this muffler I first I had it exiting completely through the rear bumper and later on I dumped it after the axle under the truck. Both ways this muffler produced a great sound. Anyone who owns a Spintech can attest that they are a truly unique sound. This particular series Spintech muffler is one of their quietest mufflers in their lineup. It was made to have that same great tone on the outside without sacrificing interior comfort. This muffler gives a great burly sound at startup. It remains quite tame under normal idle. It has a nice deep tone under acceleration but really wakes up and screams at WOT. On the highway it does quiet down. Not completely but just enough so you can still tell its there.

2.) Custom Built Turndown Tips + Clamps

I also had Ron at Spintech build me these 2.5" dia. Turndown Tips. 304 Stainless was also used to make these. The ends of the tips are flanged out so that they can easily fit over 2.5" piping and either be clamped on using the supplied clamps or welded on. The clamps are nice 2.5" Clamp seal clamps from NAPA. The turndown tips also have hangers welded on to them for ease of installation. All of these pieces were also sprayed with the same VHT Cermaic coating and were also just resprayed to clean them up after uninstall.

Prices:
ALL ITEMS SOLD

The prices to me seem very fair. None of these items were cheap to make. I suppose I can entertain some offers if I have no initial bites but please don't insult me.









thanks,
Frank S.

 

sub'd, been looking for something new to try out

 

spintechs are badass and really really good sounding.....free bump.....

 

Bump. Offers anyone?

 

Stainless on the site are cheaper

 

Not sure where you are seeing that. Right off the spintech site using the link I provided above; the 8436 series muffler starts at $139.95 for the basic aluminized steel version. Using the drop down menu under materials it shows an additional $110 for full stainless and an additional $145 for polished stainless. That would make this muffler $249.95 prior to taxes (if applicable) and shipping.

 

Would you take 250 shipped to 92544?

 

Pm sent!

 

I got my shootout pro 3.5 si/so for only 140. With hanger on it too

 

Yea, also don't forget your super pro street muffler is also half the size of this muffler @ 4x6x9 compared to mine @ 4x10.5x20.
Anyhow pending sale right now to Richardman1992.