Whippled 496

iTrader: (4)

Sure, will have to wait till after work this afternoon though.

CHarris

iTrader: (5)

I'll take the vortech tank without the cap.

Shoot me a paypal invoice to CHarris@LS3Portworks.com and I'll pay it.

Whippled 496

iTrader: (4)

Dustin actually called dibs on it first so let me give him the measurements and see if it will work. If not its all yours. I will let you know this evening.

Whippled 496

iTrader: (4)

Measurements are 11"L x 7.75"T x 7"W

The top drops down 1" to 6.75"T on one side.

Let me know Dustin.

Hugger

iTrader: (21)

Please enlighten me on the 2 injectors mounted in the block. I have no idea what they do but I am very intrigued by them. Where exactly does that hook up to the fuel system. Good luck with your sale.

Whippled 496

iTrader: (4)

They mount on the whipple supplied manifold inlet. They are part of the add-on injector setup that comes with the blower kit (which I also have for sale). I have the fuel lines that hook to them as well. I suppose if you're interested i can throw the fuel lines and the manifold inlet in there and make it a combo deal.

I can do the inlet + 2 fuel lines + injector block for $50 + $15 shipping. That goes for who ever wants them.

green6.0

iTrader: (8)

how much of the stock pipe do you have with the muffler?

Whippled 496

iTrader: (4)

They were cut about 12" after the cats. I have everything from there back. I had to make 1 cut where the pipe went over the axle because the truck wasn't on a lift when i swapped it out for the Corsa system. Two cuts total were clean and done with an exhaust cutting tool, not a recip. saw. You can pull up the Corsa #14290 install manual to see exactly where the cut was made.

laynlow77

iTrader: (8)

just so you know, this is a GREAT add-on second heat exchanger for the radix guys. it fits perfectly in between the frame rails and below the stock one.

Whippled 496

iTrader: (4)

Thanks for the input. I cant send you any commision though LOL!!