Swap to old style trans. bell housing.
03-28-2010, 03:42 AM
#1
On The Tree
Thread Starter
iTrader: (5)
Join Date: Jan 2005
Location: Bandera, TX
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
Swap to old style trans. bell housing.
This is a Keisler Engineering Titanium/ Aluminum Swap bell housing. It will enable you to Put any old style manual behind an LS1 such as muncie, t-10, richmond, TKO-500/600, will all work with this bell. Paid almost $300, looking to get $175 shipped to the lower 48.
03-29-2010, 05:38 PM
#4
12 Second Truck Club
iTrader: (13)
Join Date: Sep 2008
Location: Duncan, OK
Posts: 801
Likes: 0
Received 0 Likes
on
0 Posts
Other than the material/strength, do you know what the difference is between this and the stock bell housing. I know the 4 speed to SBC bellhousing will bolt up to the ls blocks, but it's a bit too long. If this is will help solve my problems then consider it sold! lol I just need to know if it's the correct length so I can use my LS1 clutch setup and my starter.
03-30-2010, 05:07 AM
#5
On The Tree
Thread Starter
iTrader: (5)
Join Date: Jan 2005
Location: Bandera, TX
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
i will measure it when i get home, but its designed for the ls1, I used it to put a tko 600 behind my 6.0 with a ls1 flywheel and clutch and worked perfect.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
CammedZ71
Tuning, Diagnostics, Electronics, and Wiring
2
08-02-2015 01:44 AM
