SOLD

I’ve got a used Innovate XD-16 AFR gauge for sale. It works great, no scratches or blemishes. What’s in the pic is what you get.
I am throwing in the LC-1 wideband O2 system. Here’s the catch, the XD-16 reports perfect AFR with this system, however, the analog outputs quit working. So you can’t log AFR with HPT or EFI Live etc…
If you’re just looking to have an AFR gauge in your ride then this is a cheap way to get it done. The XD-16 alone is worth more than what I am asking for the whole kit. $150 shipped. I take PayPal.

What’s included:
1 XD-16 Gauge
1 Terminator plug
1 2.5mm to 2.5mm extension cable
1 LC-1 controller
1 Oxygen sensor
1 Serial to2.5mm connector for programming the gauge
The software to program (LM Programmer) is available on Innovates site for download

 

Doesn't the lc-1 have a serial output that could be used with efi flash scan v2?

 

I dont think so. This LC1 has 7 wires and two 2.5mm jacks on it and that's it.

Sale Pending...

 

I can clearly see the serial cable in the middle of your picture. This efi live page also lists the lc1 as a support device to send afr information directly into the software.

Supported Serial WBO2 Controllers

Let me know if the deal falls through, I'm interested.

 

I did not know that. I use HPT in my truck now so it wouldn't have helped in my case but still good to know. I guess the 2.5mm ports can be used to feed info out as well as load programming in. It makes sense because the XD-16 has a record function and it is fed by the 2.5mm port.
Innovate also has a program called "Log Works" that you can record info with.
I just liketo plug in my HPT analog output and go...that's why I'm replacing this with another Innovate product.

I will post up if the other deal falls through and you are next in line.

 

Sold!

 

Just curious...what did it do when the analog out stopped working? I have two LC-1 widebands failing me right now...

 

Innovate said they usually just quit provinding a signal completely. Mine were still reportingb but off by 2 to 5 full points. So 14.7 was reading 11.0 or 17.0 etc..I even programed the gauge to report 10.0 at 0-5 volts and it still sent out random readings. I tried ground offsets, free air calibrations, used a volt meter on it..everything was out of wack.