Anyone still running a PVC 4in intake setup?
#44
TECH Enthusiast
iTrader: (5)
siliconeintakes dot com. I tried the hardware store stuff but it didn't work out, so I bit the bullet and ordered stuff. $65 shipped and that was everything but the tube, which was about $3 from hardware store. Only problem was 2 of my hose clamps were too small
I used 4"-4" elbow, 4"-3.75" reducer, 10mm vacuum hose, 1/4"NPT x 3/8th barbed brass fitting, couple .5" clamps, one 3.75" clamp, one 4" clamp and need two more 4.5" clamps.
I used 4"-4" elbow, 4"-3.75" reducer, 10mm vacuum hose, 1/4"NPT x 3/8th barbed brass fitting, couple .5" clamps, one 3.75" clamp, one 4" clamp and need two more 4.5" clamps.
Thread
Thread Starter
Forum
Replies
Last Post
lxcoupe
FORCED INDUCTION
8
07-21-2015 02:12 AM