Boil and pressure test heads?
#14
Yes pressure check them, you never know with used parts.
Do it right and do it once. Or cheap out, be lazy and half *** it 3 or 4 times. Your choice.
Do it right and do it once. Or cheap out, be lazy and half *** it 3 or 4 times. Your choice.
Last edited by 1994Vmax; 01-17-2012 at 07:31 PM.
#15
MASS seller approved
Thread Starter
iTrader: (19)
Join Date: Jan 2011
Location: Hampton bays, new york
Posts: 288
Likes: 0
Received 0 Likes
on
0 Posts
Thats my reason for asking I know casting has come a long way but all it takes is one good overheat to crack a port on the in side and a lot of money can be wasted to find out the wrong way. I originally asked because ten yrs ago when I would put a block together it was common practice because UD look like a real *** if the head u just spent a cust. Money on where no go . But either way any feedback is good feed back some people have been lucky and never had a bad head that's was suppose to be good. ( now that statement proir can definitly be twisted)Thanx again to everyones replies.
Thread
Thread Starter
Forum
Replies
Last Post
superchomper2003
GM Drivetrain & Suspension
3
08-26-2015 09:39 AM
05GMC4.8
GMT 900 Trucks General Discussion
5
08-07-2015 09:55 PM