Limp Mode after 1st start of the day
#1
TECH Fanatic
Thread Starter
Join Date: Jan 2005
Location: Lafayette, Louisiana
Posts: 1,489
Likes: 0
Received 0 Likes
on
0 Posts
Limp Mode after 1st start of the day
When I crank the truck for the 1st time in the morning it runs fine for a couple of mins then when I get around the corner it goes into limp mode and the SES light flashes at me. It will do that for a few mins then go right back to running fine and the flashing light goes away. Then it runs fine the rest of the day.
This did it once about a week ago and I thought it was just a glitch but now its done it the last 2 days in a row.
Im going to reflash the PCM this afternoon. is there anything else that you can think of that it might be?
Also I have a wheel bearing assy (that has the ABS built into it) that has gone bad and being changed this morning, Could that cause the limp mode?
This did it once about a week ago and I thought it was just a glitch but now its done it the last 2 days in a row.
Im going to reflash the PCM this afternoon. is there anything else that you can think of that it might be?
Also I have a wheel bearing assy (that has the ABS built into it) that has gone bad and being changed this morning, Could that cause the limp mode?
#3
TECH Fanatic
Thread Starter
Join Date: Jan 2005
Location: Lafayette, Louisiana
Posts: 1,489
Likes: 0
Received 0 Likes
on
0 Posts
I have HP Tuners and it would not store a code.
I think I had a corrupt tune so I went back to the tune before and it has been working fine ever since.
Thanks for the reply
I think I had a corrupt tune so I went back to the tune before and it has been working fine ever since.
Thanks for the reply
Thread
Thread Starter
Forum
Replies
Last Post
Mossyoakglock
GMT 900 Trucks General Discussion
4
08-28-2015 12:49 PM
superchomper2003
GM Drivetrain & Suspension
3
08-26-2015 09:39 AM
shupe
GM Drivetrain & Suspension
0
08-05-2015 06:45 PM
Mossyoakglock
GMT 900 Trucks General Discussion
0
07-17-2015 08:30 AM